Notes on installation and skills of wood drying equipment

　　When installing the wood drying equipment, it is necessary to check whether the position to be installed is appropriate, so that other problems will not occur during the installation, and in the future use, it will not cause future maintenance inconvenience and other problems due to the error of preliminary installation. The installation is mainly to check the pouring quality and dimensional position deviation of the foundation concrete: in appearance, the foundation surface is required to be clean, free of oil, dust and sundries, no exposed reinforcement, no crack and corner, no residual shell and fender in the expected reserved hole, and other pouring defects. The deviation of foundation size and position shall meet the following requirements.

　　The error of overall dimension and basic coordinate position, vertical and horizontal axis is less than 20 m m. The error of different plane elevation is less than 20 mm, only negative is allowed, and no positive is allowed. The error of slope is less than 20 mm in total, and no positive is allowed at the discharge end. The non flatness of upper plane is less than 5 mm / m, and the total length is less than 10 mm. The equipment acceptance checks the parts, components, standard parts, random documents, etc. against the packing list of the equipment No missing parts, deformation, damage, etc., and make records for purchase or preparation before installation. Remove the protective coating, dust, oil stain, rust and other conditions when packaging, and check the damage and deformation caused by the repair during the transportation and loading and unloading process. Pre test and pre assemble parts and key mating parts to avoid rework during installation and ensure installation progress and quality.

　　Using skill of wood drying equipment

　　As a fully automatic machine, the wood drying equipment is not only easy to operate, but also effective and efficient. There are more and more enterprises that like the equipment. There are still some tips to share when using the equipment. Before crushing, it is necessary to stop the preliminary screening with a screening machine or a washing machine, etc., so as to remove the iron blocks in the ore that are difficult to be broken. Do not stop the start-up when the wood oven is loaded. Only after the crusher operates normally can it start feeding. The crushed materials shall participate in the crushing cavity evenly, and side feeding or stacking charging shall be prevented to avoid unilateral overload or overload acceptance. After one end of the toothed plate is worn, it can be used in a reversed way. Under normal conditions, the temperature rise of the bearing shall not exceed 35 ℃ and the maximum temperature shall not exceed 70 ℃. Find out the cause and eliminate it.